激光导向伺服系统中满意PID调节器的LMI设计

利用带有图像处理功能的小型激光导向伺服系统,可以大大降低目标坐标测定仪操作手跟踪动态飞行目标的操作难度,从而提高激光回波率.与经典的矩阵分解方法不同,本文以线性矩阵不等式方法,研究了激光导向伺服系统的满意PID调节器设计问题.首先从约束指标的相容性出发,给出满足与给定圆形极点约束相容的输出方差的取值范围.然后,在此取值范围内,得到了求取同时满足上述两种约束的PID调节器参数的方法.靶场试验结果证明了其有效性.     

高铬锰白口铸铁的软化处理

研究了 4种退火工艺对高铬锰白口铸铁组织和硬度的影响规律。结果表明 ,采用 85 0℃保温 4h ,随后于 72 0℃保温 6h退火工艺 ,硬度最低为 36～ 38HRC ,机加工性能最好。     

入侵检测及网络层安全的研究

随着计算机网络的迅速发展，网络安全问题正变得日益重要。文章介绍了计算机网络系统IP层安全概况和入侵者对IP层常采用的入侵手段，以及为防止这种入侵所采取的措施。     

Investigation of the source/drain asymmetric effects due to gate misalignment in planar double-gate MOSFETs

A planar double-gate SOI MOSFET (DG-SOI) with thin channel and thick source/drain (S/D) was successfully fabricated. Using both experimental data and simulation results, the S/D asymmetric effect induced by gate misalignment was studied. For a misaligned DG-SOI, there is gate nonoverlapped region on one side and extra gate overlapped region on the other side. The nonoverlapped region introduces extra series resistance and weakly controlled channel, while the extra overlapped region introduces additional overlap capacitance and gate leakage current. We compared two cases: bottom gate shift to source side (DG/spl I.bar/S) and bottom gate shift to drain side (DG/spl I.bar/D). At the same gate misalignment value, DG/spl I.bar/S resulted in a larger drain-induced barrier lowering effect and smaller overlap capacitance at drain side than DG/spl I.bar/D. Because of reduced drain-side capacitance, the speed of three-stage ring oscillator of DG/spl I.bar/S, with 20% gate misalignment length (L/sub mis/) over gate length (L/sub g/), or L/sub mis//L/sub g/=20%, was faster than that of two-gate aligned DG-SOI.     

天津通信企业IT信息网络支撑平台

从系统建设背景、关键技术、创新点及应用情况等方面介绍了天津市通信公司企业IT信息网络支撑平台是一个统一、高效、简洁的综合业务网络平台。     

无线技术的新领域--WUSB

无线USB(WUSB)技术是一个全新的无线传输标准.实现USB(通用串行总线)无线化以后,既可以保持有线USB的高速传输等优点,又可以去掉电缆的羁绊,给各种设备带来更大的便捷和移动性.文中首先介绍了WUSB技术的由来--UWB技术规范的标准化难以确定,然后对WUSB技术的规范标准进行了阐述,最后概述了WUSB技术的发展现状及目前和今后的技术研发重点,并对WUSB的发展前景进行了展望.     

An investigation into physicochemical characteristics of ash produced from combustion of oil palm biomass wastein a boiler

Ash derived from combustion of Malaysian oil palm biomass (empty fruit bunches consisting of fibers) was physically and chemically characterized in order to provide a comprehensive understanding of its specific properties in terms of toxicity, compositions and reusability. Principal analyses conducted include particle size distribution, scanning electron microscopy, elemental dispersive X-ray, elemental analysis, toxicity characteristic leaching procedure (TCLP) as well as thermogravimetric, X-ray diffractometry and Fourier-transform infrared analyses. TCLP result indicated that the oil palm ash (OPA) should not be classified as toxic wastes in terms of heavy metal leachability since leachable copper, cadmium, lead and nickel concentrations were detected below the stipulated leachability limits. It was determined that the OPA contained high amount of potassium as well as presence of silica which implied its suitability to be reused as crude fertilizer or cement replacement material.     

控制性水库建设模式研究

水库梯级（尤其是控制性水库梯级）的建设在西南水电开发中具有举足轻重的地位。但控制性水库梯级一般位于河流上游，为获得需要的调节库容，要求有较高的坝，从而增加筑坝的难度，水库淹没较大，相应的投资亦较大，故经济性相对于其它类型的电站较差。为促进控制性水库梯级的建设，有必要对控制性水库的建设模式进行研究，寻求其可能的投资分摊方式。本文在合理核算上游控制性水库梯级对其下游梯级受益电站补偿调节效益的基础上，对上游控制性水库梯级建设模式进行了研究，提出了控制性水库梯级几种可能的建设投资分摊模式。     

直接利用净化海水生产酱油

通过净化海水并作为酿造酱油用水的整个生产研究,结果表明米曲霉能够在三角瓶、通风制曲等生产过程中正常生长,其外观、孢子数、发芽率和自来水酿造的无明显差别,培养过程减少细菌总数44.8%、发酵过程减少28.1%;海水酱油的各项指标均符合GB18186-2000《酿造酱油》标准要求,而且感官指标更佳;说明利用净化后的海水代替自来水进行酱油生产是可行的,并直接节约生产成本每吨70元,出品率提高3%左右,具有显著经济效益.